AUGEAS TECHNOLOGIESReuse your pipette tips, up to 50 times.
A precision cold-plasma system that cleans labware on-deck, between runs, so you cut consumable cost and plastic waste without changing your assay results.
Tips reused
The same tips go back to work, run after run.
Assay performance
Performance comparable to new tips in the published cell-based assay.
Of tip integrity
Geometry intact through 40 cycles, minor tip-end wear at 50.
Clean on-deck. No workflow change.
Run your assay
Use your liquid handler exactly as you do today, no workflow change.
Clean on-deck
Between runs, cold plasma cleans tips and pin tools in place, without extensive solvent wash protocols, and with no manual handling.
Reuse, again & again
The same tips return to work, with performance comparable to new for up to 50 cycles.
How cold plasma cleans
Ceramic-encapsulated electrodes driven by a high-frequency, low-current source create a cold-plasma discharge, generating reactive species (ozone, activated nitrogen) that break down DNA, RNA, and proteins at the molecular level, without harsh chemicals.
- Supports 96 / 384 / 1536-well formats
- Cuts consumable use and its associated plastic waste
- Compatible with automated & manual workflows
Three parts, one clean workflow.
Plasma Charger
The plasma generation and control unit (TipCharger 4.1).
Plasma Stand-Alone
Standalone plasma module (Plasma Knife).
Cleaning Stations
96-Well, 384, 8-Channel and 1536 stations.
Cut recurring cost and plastic waste, with the same results.
In high-throughput labs, pipette tips and pin tools are treated as single-use, a constant recurring cost and one of the largest sources of plastic waste. Cold plasma cleans that labware in place, between runs, so it's reused many times instead of discarded.
Proven in published work. In a peer-reviewed study (Akhlaq et al.), pipette tips cleaned up to 50 times performed comparably to new tips in a cell-based (LPA calcium-mobilization) assay, with minimal tip wear. See the published studies
We design the high-voltage boards, the control firmware and the operator software used in plasma treatment systems that are in commercial service today. Every unit is built, wired, hipot-tested and frequency-tuned in our Hyderabad facility and exported from India. Our customers sell the finished systems under their own brands.
Ready to cut consumable cost?
Get pricing, integration specs, and the full study pack.
Email us for pricing